Speed Searchв Control: V 15.0.2

Locate the primary activation parameter in your control interface.

Set the time the drive takes to "search" down from the maximum frequency. A default of 2.0 seconds is common. 3. Verification & Safety Speed searchВ Control v 15.0.2

If you are using a specific software suite (like or Alta Control ) where "v 15.0.2" refers to a firmware version, check the Cisco Bug Search Tool or the Alta Release Notes to see if "Speed Search" refers to a new UI search optimization or performance feature. Locate the primary activation parameter in your control

To prepare or enable the feature in a control system (such as Yaskawa or similar VFD controllers ), follow these general configuration steps: 1. Enable the Speed Search Function Enable the Speed Search Function To ensure the

To ensure the drive catches the motor smoothly without tripping an overcurrent fault, adjust the search sensitivity:

Decide if you want it to trigger automatically after a power loss or every time a "Run" command is given. 2. Configure Current and Timing