: You can create complex, non-standard pad shapes by drawing the outline and using "Make Feature" to define it as a specific aperture in the D-code list.
: Use the selection tool to highlight the lines or shapes you want to combine. : You can create complex, non-standard pad shapes
: Go to Setup > Make Feature (or Edit > Make Feature depending on your specific version layout). : The software will typically ask you to
: The software will typically ask you to define the center point of the new feature, which becomes the insertion point for the flash. : You can create complex
: It allows you to select a group of primitive shapes and combine them into a single pad or "Flash." This is often necessary when a design was exported with "painted" pads (pads made of many small lines) rather than standard flashes.