Best Restaurant Franchises To Buy | TOP-RATED |

Hi all,

I'm using ST's CubeMX implementation on a F4 discovery board. I use ST's USB middlewares with FreeRTOS.

When I get a special OutputReport from PC side I have to answer nearly immediately (in 10-15 ms). Currently I cannot achieve this timing and it seems my high priority tasks can interrupt the USB callback. What do you think, is it possible? Because it's generated code I'm not sure but can I increase the priority of the USB interrupt (if there is any)?

Thank you, David

10 to 15 ms is very slow, so I'm sure its possible.

Where is the USB callback function called from? If it is an interrupt then it cannot be interrupted by high priority RTOS tasks. Any non interrupt code (whether you are using an RTOS or not) can only run if no interrupts are running.

Without knowing the control flow in your application its hard to know what to suggest. How is the OutputReport communicated to you? By an interrupt, a message from another task, or some other way?

The callback which receive the data from PC is called from the OTGFSIRQHandler (it's the part of the HALPCDIRQHandler function). I think the problem is SysTickHandler's priority is higher than OTGFSIRQHandler and it's cannot be modified, but the scheduler shouldn't interrupt the OTGFSIRQHandler with any task handled by the scheduler. Am I wrong that the scheduler can interrupt the OTGFS_IRQHandler?

: Offers lower net worth requirements than many burger-focused national chains.

For investors looking for rapid expansion or specific niches like "Fast Casual," these brands show strong momentum for 2026. Investment Range Mexican QSR $934K – $4.3M Jersey Mike’s Subs Sandwiches $203K – $1.3M Wingstop Chicken Wings $298K – $1.0M Crumbl Cookies $400K+ (est.) Low-Cost Entry Options

: Most brands require at least $500,000 in liquid capital (cash or easily accessible assets) regardless of the total loan amount.

Before committing, review the following critical factors often found in the :

Thank you for the answer, I think I'm a bit confused with the Cortex ISR priorities :-) What I can observe is if I use a much higher osDelay in my high priority task I can respond for the received USB message much faster. This is why I think tasks can mess up with my OTG interrupt.